FAQs

About Continental Riflescopes

Q: Hello, I want to buy the best and most expensive riflescope in Vector Optics.

A: Our Continental have the best image quality and mechanical quality.

Continental series is our very outstanding product line.

It has German glasses and the outstanding light rail system.

It is under our life-time warranty.

About Frenzy series red dot sight footprint

A: Our Frenzy-X has 2 types of footprint, TEK and MOJ.

Our Frenzy-S has 1 type of footprint, MAG.

TEK footprint is same with Docter, Vortex Venom/Viper, Burris Fastfire.
MOJfootprint is same with Trjicon RMR.

MAG footprint is same with Shield.
If you have any questions about this, welcome to contact us. we can help you choose.

Why my Frenzy red dot can't turn on?

If the red dot did not turn on at the first time you received it, please check below 2 tips ：

#1 Is it possible to try different brand
batteries of CR2032 3.0V ? Because some customers made the feedback that their
red dots did not turn on when they put new battery inside, but the red dot turn
on normally after they put different brand battery inside.

#2 Please pull the circuit metal
contact.

If the red dots not able to turn on after several shots,
#3 Please pull the circuit metal contact

Why my Maverick red dot can't turn on?

#1 Simple Try

(1)Please try different brand
batteries of CR2032 3.0V. Because some customers made the feedback that their
red dots did not turn on when they put new battery inside, but the red dot turn on normally after they put different brand battery inside.

(2) Please pull the metal contact.

#2 Little complex try

Step 1 : Relax the screw.

Step 2 : Put battery directly on the metal contact “+” and “-”.

Step 3 : Look Through the red dot / Take a photo.

Step 4 : Assemble ! Make sure the “·”+“0”+“|” at the same line.

Why I can't adjust my scope?

#1 Is it possible to help do a “Box Testing" of the adjustment?

(1) Tighten the rifle

(2) Put a paper at 100 yds(MOA) /
meters(MIL)
(3) Adjust the elevation turret from the "Up" to "Down" , adjust the windage turret from the “left”
to “right”
(4) Record the distance that reticle's movement on the paper

#2 If the “Box testing” works well.Please check below 5 tips:
(1)Are the rings installed too tightly ? (The suggested screws Torque is 15-18 Inch-pounds, Over torqueing the ring screws
will cause excess pressure on the tube, which will cause problems when adjusting the reticle/adjustment.)

(2)Has the windage or elevation turret been adjusted to the ultimate position ? For example the most left/right or the most
up/down. (Reason : “ windage adjustment” and ” elevation adjustment ”, they are both adjusted in the same inner tube of the riflescope which means the windage or elevation adjustment will influence each other )

(3)Would like to know the height of the center of the scope from the barrel?
(4)Is it possible to tell me the distance riflescope used ? what is your bullet drop at such distance ？

(5)Have a try to exchange the position of front ring with back ring.

Many times, problems thought to be with the scope are actually mounting problems. Be sure the mounts are properly torqued
to the rifle and the scope is secured so it doesn’t twist or move in the rings.
An insufficient windage or elevation adjustment range may indicate problems with the base mount, base mount holes drilled in the rifles receiver, or barrel/receiver alignment.